STEP ONE
TECHNICAL PRODUCT BULLETIN #B-43
USEPA, OEM REGULATIONS IMPLEMENTATION DIVISION
ORIGINAL LISTING DATE: MARCH 12, 1992
REVISED LISTING DATE: MARCH 21, 1997
"STEP ONE"
(a/k/a B&S INDUSTRIAL)
LISTING CHANGES PENDING; VERIFICATION BY MANUFACTURER AND EPA REQUIRED
| I. NAME, BRAND, OR TRADEMARK |
|---|
| STEP ONE Type of Product: Biological Additive |
| II. NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT |
|---|
| B & S Research, Inc. 4345 Highway 21 Embarrass, MN 55732 Phone: (218) 984-3757 Fax: (218) 984-3212 Email: farmforprofit@frontier.com (Mr. H.W. Lashmett) |
| III. NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS |
|---|
| B&S Research, Inc. 4345 Highway 21 Embarrass, MN 55732 Phone: (218) 984-3757 Fax: (218) 984-3212 Email: farmforprofit@frontier.com (Mr. H.W. Lashmett) Bioremediation International 4345 Highway 21 Embarrass, MN 55732 Phone: (218) 984-3757 Fax: (218) 984-3212 Email: farmforprofit@frontier.com Farm for Profit Research and Development 4345 Highway 21 Embarrass, MN 55732 Phone: (800) 232-7692 Fax: (218) 984-3212 Email: farmforprofit@frontier.com |
| IV. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION |
|---|
| 1. Flammability: None 2. Ventilation: Normal ventilation is adequate 3. Skin and eye contact; protective clothing; treatment in case of contact: Avoid contact with skin, especially when there are open wounds. In case of skin contact, wash with soapy water. The use of protective gloves is recommended. Avoid contact with eyes. In case of eye contact, immediately flush eyes with plenty of water continuously for at least 15 minutes. Consult a physician. The use of protective goggles is recommended. Avoid inhalation and ingestion. It is recommended that workers wear dust mask and not eat or smoke while handling the product(s). 4.a. Maximum storage temperature: 90ºF 4.b. Minimum storage temperature: -30ºF 4.c. Optimum storage temperature range: 32ºF to 70ºF 4.d. Temperature phase separations and chemical changes: NA |
| V. SHELF LIFE |
|---|
| Over 3 years |
| VI. RECOMMENDED APPLICATION PROCEDURE |
|---|
| 1. Application Method: Components of the product STEP ONE (BC101) and STEP ONE (MSE2.5) are only sold together. B&S Research will make application recommendations based on contamination and ppm of contamination at time of purchase order and employ specified application methods (spray, plowing, agitation, etc.) appropriate for a particular situation. 2. Concentration/Application Rate: Nominally, the STEP ONE water mixture can be used on most hydrocarbons, including crude and refined petroleum products, pesticides, etc., on land, fresh water or ocean water. Laboratory tests also indicate effectiveness in destruction of PCB's. In certain circumstances, B&S Research, Inc. may require laboratory soil and water contamination tests before the product may be used (see VI 1. above). |
| VII. TOXICITY AND EFFECTIVENESS | ||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| a. Toxicity: NA b. Effectiveness: Bioremediation Agent Effectiveness Test (40 CFR 300.900), Federal Register September 15, 1994: Summary Data Table:
Results of Gravimetric Analysis: Percentage (%) Decrease in Weight of Oil on Day 28 Control: 0% Nutrient: 19% Product (STEP ONE): 51% |
| VIII. MICROBIOLOGICAL ANALYSIS |
|---|
| 1. Listing of all microorganisms by species and percentages in the composition: CONFIDENTIAL 2. Optimum pH, temperature, and salinity ranges for use of the additive: pH: 6-8 Temperature: 70ºF to 90ºF Salinity: Fresh or salt (ocean < 110 ppm) water, land or dry surfaces 3. Minimum and maximum pH, temperature, and salinity levels below or above which the effectiveness of the additive is reduced to half its optimum capacity: pH: < 5 or > 9, (apply neutralizing agents -- lime or P205) Temperature: < 50ºF or > 135ºF Salinity: < 0 or > 110 ppm 4. Special nutrient requirements: None 5. Test results regarding the determination of the presence of the following: Salmonella: None found Fecal coliform: None found Shigella: None found Staphylococcus coagulase positive: None found Beta hemolytic Streptococci: None found |
| IX. PHYSICAL PROPERTIES |
|---|
| 1. Flash Point: > 212ºF 2. Pour Point: -7ºF 3. Viscosity: 2.8 cst at 50ºF 3 5 cst at 32ºF 5.9 cst at -4ºF 4. Specific Gravity: 1.03 at 59ºF 5. pH: 7.2 (1:2.5:80 BC101:MSE2.5:water mixture) 6. Chemical Name and Percentage by Weight of the Total Formulation: CONFIDENTIAL 7. Surface Active Agents: Noedal 8. Solvents: None 9. Additives: Phosphoric acid as P205 3% emulsifier < .5% by weight 10. Solubility: Infinite |
| X. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|